Масло. В случае, если меняем компоненты, но не промываем систему (когда часть масла остаётся в системе):
INSTALLATION SERVICE POINT
<A> COMPRESSOR INSTALLATION
If a new compressor is installed, first adjust the amount of
oil according to the procedures described below, and then
install the compressor.
(1) Measure the amount [X cm3 (X fl.oz.)] of oil within the
removed compressor.
(2) Wipe away (from the new compressor) the amount of
oil calculated according to the following formula, and then
install the new compressor.
New compressor oil amount 160 cm3 - X cm3 = Y cm3
(5.4 fl.oz. - x fl.oz. = Y fl.oz.)
NOTE
(1) Y cm3 (Y fl.oz.) indicates the amount of oil in the refrigerant
line, the condenser, the cooling unit, etc.
(2) If any other air conditioning part is replaced simultaneously
with the compressor, remove the oil from the new
compressor, taking the specified amount of oil for the
part into consideration.
Quantity
Evaporator: 60 cm3 (2.0 fl.ot.)
Condenser: 15 cm3 (5 fl.oz.)
Suction hose: 10 cm3 (.3 fl.oz.)
Receiver: 10 cm3 (.3 fl.oz.)
Compressor oil:
FREOL S-83 or SUNISO 5GS <Vehicles using R-12
refrigerants
SUN PAG 56 <Vehicles using R-134a refrigerant>