Блин точно. туплю
Цитата:
|
Tap off of wire 105 (orange) with either a 12volt internal resistor LED (available at some Radio Shacks) or use a regular LED with a 470 ohm resistor in series (Do not use regular indicator light bulbs). You must have either the boost control solenoid installed even if you're not using it or solder a 40 ohm resistor in it's place. Whatever you do don't just short the 2 wires together or you can damage the ECU. The LED will not work without either the resistor or boost control solenoid installed.
|
Не понял перевод вот этого момента
Цитата:
|
Whatever you do don't just short the 2 wires together or you can damage the ECU.
|
Чем можно угробить ECU?
Цитата:
|
The LED will not work without either the resistor or boost control solenoid installed.
|
Светодиод не будет работать без резистора или буст контроллера. Тут то же них*я не понятно.
Цитата:
|
You must have either the boost control solenoid installed even if you're not using it or solder a 40 ohm resistor in it's place.
|
А тут наоборот. Типа можете установить буст контроллер, но не использовать сопротивление в 40 ом?
Йа креведко оО