Цитата:
I used those setting above to setup the injectors. Then all I did was copy all the MAF settings out of the 20550011 from a 98 GST. The V7 roms makes it really easy, since the MAF Scaling in supposed to be included.
I loaded up the 96530706 rom with these changes:
Turned off MAP averaging
Dropped knock flash to 755ms
Injector Scaling 424
Injecto Latency
4.69v = 3.825
7.03v = 1.815
9.38v = 1.125
11.72v = 0.795
14.06v = 0.585
16.41v = 0.435
18.68v = 0.315
MAF Size = 286.0
Changed MAF Scaling to 2gMAF + 64Adder
MAF Compensation from 2g
MAF Sensor Filtering from 2g
Baro Comp from 2g
Knoch Multiplier - Low RPM to 24
Immobilizer Disabled
It ran pretty good. The Low LTFT dropped to -6%, the Mid LTFT was also near -6%. This is consistent with the trims I had with my stock ECU, bothstock and modded.
It would run a bit lean here and there. But I didn't have lean spool turned off. I'd say it's a good enough starting point for anyone. Some tweaking to it would probably yield gains on an individual basis.
__________________________________________________ ______________________________________
Here's the MAF Scaling table from V7. Remember V7 has the adder already in the scaling. Previous versions don't.
|
ROM -> http://ceddy.us/flash/20550011-mod-1v4.bin
XML -> http://ceddy.us/flash/20550011.xml
для тюнерс прокси нужен.
__________________
ИМЕЕТ ЗАДОЛЖЕННОСТЬ ПО СДЕЛКАМ НА ФОРУМЕ НА СУММУ ОКОЛО 35 000 РУБЛЕЙ
Последний раз редактировалось Ali_G; 04.06.2010 в 00:52..
|